Recent content by bobcat

Hi all i have a 1977 wadkin ags 10 table saw i have been restoring, can anyone tell me the v belt size it is a rare single phase unit with the original brooks motor fitted, all help apreciated thanks Bobcat

That is the wrong blde size it should not pertrude out of the lower finger gaurd fit a 10"/ 255mm blade problem solved me thinks

take some photos and post them here

does the blade sit completely behind the fence when fully back agains the stop?

i have just been out gto measure mine it is 255mm and does not foul anything post some pictures the 1751 is a long arm version of a 1251 also 255mm

Hi i thought the 1751 was a 255MM blade not 300MM i will measure mine tomorrow also is it the blade or the guard hitting when in the 90deg to the table is it hitting?

Welcome Roger another Devonion here Great Torrington Devon, Castle Drogo is now completely restored and dry, my work shop slopes as does my house l.o.l

Thanks for the picture i have sort of worked it out now, mine has only one 20mm rod which suprisingly i have

Hi all long time no posting , need help i have recently completely rebuilt a Kity 636 planer thicknesser, But it came to me without a fence, is there anyone out there that could take and post some detailed pictures so i can attempt to replicate one , thanks in advance Bobcat

sadly i agree i modded mine to take alater 1725 gaurd and that includes a riving knife and an anti kickback pawl, with pressure roller mine als will take a full dadostack which i have also used in the rip position, also when setting the table up you need to cut an inverted cove into the table...

well i use a r.a.s for virtuatly all the work i do, never suffer with kick back when ripping, or poor alinment after saw has been set into rip or miter cuts, initial set up is a pain but once done no problem at all , but then again mie is a solid castiron 1030 square arm from the late 1950's

The bearings for these saws are available from any uk bearing supplier, i have re bearinged many inca machines over the years of repairing woodworking machines all well nearly all bearings are marked with a unique number so it is easy to identify them Regards Bobcat

The bearings for these saws are available from any uk bearing supplier, i have re bearinged many inca machines over the years of repairing woodworking machines all well nearly all bearings are marked with a unique number so it is easy to identify them Regards Bobcat

Hi all aquired an elu 4001 d/t jig does anyone know the size and dimentions of the router bit/bits that fit this jig. i have the 11mm guide bush but no instructions or bits Bobcat

Sorry that should read 40001 d.t jig :shock: