Thanks. Yes I assume it should be fully closed unless there is a blockage and then it does what it is supposed to but I can hear the air coming through when it's just the Henry on. I'll see if I can find another spring and see if the extra tension helps.
So I've put everything together but the anti crush valve appears to be 'too' open which means that the amount of suck is reduced so much it doesn't really work. I've tried adjusting but it doesn't seem to do anything. When holding the anti crush valve closed the suck improves but then obviously...
Thanks for that. I had seen the 28mm hole cutter would be required so will get one of those if I haven't got one already.
At the end of the day I'll be reducing the hoses at one end or the other because the cyclones all appear to be around 50mm and the equipment I will be using on for dust...
I have decided to go with the barrel route and will get a 60l barrel and pressure release valve. What I would like to know is what size hose I will need? I have two standard size Henry hoses already so would these be sufficient or should I get something bigger? It appears the Cyclone inlet /...
Okay thanks, I have plenty of ply in the garage so could use that. Could also go the barrel route. Thanks for the info, have given me something to think about.
Thanks, I actually recently bought another hose for it so have two already so that is good. When making the box did you use silicone to seal the parts or just glue them?
Thanks, it appears a lot of people do use the Henry with good effect and the 60l barrel route was the one I was thinking of trying. I guess I might as well try it with the Henry I already have than go and spend on the Record DX1000. Not sure what more the Record would give. If anyone can advise...
I have a circular saw which I use to cut down full plywood sheets but I find the table saw really handy when needing repeated cuts and can use the cross cut sled. I know I can't stop dust all together but just trying to minimise. Not sure if a track saw would be ideal for what I need. Thanks though.
Thanks guys for the info / advice. Think I'll do something with the table saw like building a stand for it which I can then enclose with a dust port and this should help stop the dust dropping straight on the floor. Will then sort a Cyclone for the Henry and maybe go for the Record air scrubber...