The above photos show what my bandsaw is connected to.
However I've just located the fuses of the bandsaw as per the bottom of the two photos and found the middle of those three fuses blown. It says 20 amp on the fuse itself. I reached the wire, switched it on and it worked byt fir a split...
My brilliant Startrite 24-S-5 has just developed a problem. This morning it was working fine. I then put, a new blade on it turned it on but the small metal block behind the blade that helps in stopping the blade being pushed back as you feed work going into it, pinched to much and stopped the...
Can anyone recommend a decent Air nail gun? It's for firing brads from 8mm to 50mm long.
I had an Axminster one for years until it "gave up the ghost."
I recently bought a Draper one and its useless.
Thanks
Arnold9801
I'm a beekeeper in my spare time and with an up and coming local Bee/Honey exhibition, I would like to make a magnified bee frame exhibit.
Idealky I would like to make a 4:1 scale model of the frame. They actually measure approx 380mm x 250mm.
The hexagonal cells of the frame will need to...
Very shortly I'll be boarding the partition walls on our new build. I've done all the studs but I'm wondering if theres a low key laser tool I could use for highlighting the vertical lines for when it comes to screwing the boarding to the studs?
I've marked the centres of the studs on the...
I use these for cleaning of my beehive frames, but today it was knocking off after a few minutes.
Can anyone advise me on whether this is simply due to a faulty thermostat and if so are they readily available?
Regards
I'm thinking of changing my existing Elektra Beckhum Cross cut for a new one. It's been a brilliant tool and have had great use out of it for 26 years but would appreciate an update.
I particularly want the new saw to have the trench cut facility which is not on my Elektra.
I seem to be...
I'm thinking of changing my existing Elektra Beckhum Cross cut for a new one. It's been a brilliant tool and have had great use out of it for 26 years but would appreciate an update.
I particularly want the new saw to have the trench cut facility which is not on my Elektra.
I seem to be...