Recent content by alunt

I get mine from here: http://www.britishhardwoods.co.uk/skirt ... raves.html Usually a 3 week turn around

Mcluma: Thanks for the reply. I actually figured it in the end by trial & error. I got the radius with a 20mm flat bit. I made a template from MDF, which after a bit of faffing got perfect then used the template with a flush trimming bit to form 3 oak inserts. Job done. I've hung the first...

As a Gas Engineer myself I concur that all the above answers are correct. Manufacturers Instructions are the final say - they over-rule Gas Safe Regs, so read the Boiler Manual!

I use the Garret detector as well

Sorry to resurrect an old thread again... but... Question for Mcluma: How did you work out the radius required to make your inserts? I've just bought the Trend Hinge Jig to fit Eclipse Stainless Steel radius hinges on my oak doors and have run into the same problem of the cutter taking too...

I moved into my current home in 2010 just before the -18 Degrees winter. After spending £300 every 6 weeks on LPG heating i decided to rip out all the walls in the Lounge, replace them with 3x2 CLS 50mm Kingspan/Celotex and tapered edge plasterboard (12.5mm on the walls, 9mm on the ceiling). No...