hi thanks for for you replies guys dibs i was thinking of epoxy but the problem is the risers have cracks as well and in some treads and risers have half a centimeter gap so the squeak quite badly.
james hi i read some were that mdf is not a good choice for for treads. may be i am wrong i...
hi olly thanks for quick reply.its a winder staircase i think..... and at the moment it has 32mm pine treads they have very large cracks in them.
ahmad
Hi guys need some advice i am about to refurbish my staircase and thinking of changing the stair treads old ones have far to many nails and cracks bad rely bad. can i use 32mm laminated hardwood boards for treads and if anyone know any timber merchant who has them. for risers i am thinking 18mm...
hi i have just received this email offer from rutlands tools on router cutter set Tornado Complete Door and Drawer Making Set -1/2" Shank i am new to routers. the only cutters i have is a set form wicks. i have recently built my router table and i think i am ready experiment on my newly built...
hi steve thanks for you replay i have viewed this clip. but the problem is still there even on small 47cm pice of softwood. snipe is not there when i am planing.
ps: i always view you youtbe video and i think you videos are the best.
ahmad
hi blister,
thankyou for you quick replay i got this planer thicknesser second hand about 9 months a go i think it is 4 years old the pices i am thicknessing at the moment are 47cm and i am getting snipe at both ends about 4.9mm. i am have attached a pic of the gauge i am using. i dont have...
hi guys
i have a record pt260 planer thicknesser the problem is with the thicknesser. i am getting snipe on both ends of the board and in the middle of the board slight ridges i have taken some pics. baldes are just been sharpend and they are set useing gauge provided with
the mechien. could it...
hi
i have purchased Startrite 502e bandsaw and it is excellent and heavy very smooth to run. i also ordered some blades from tuffsaw.
thankyou for your help guys
regards
ahmad
hi guys thankyou very much for the info i will be dropping the Knives to Southern Counties Saws later to day. and again i would like to thank you guys for the quick respons i recived.
Ahmad
:-D
hi,
hi does any one know place where i can get sharpened my planer thicknesser blades preferably near uxbridge west london or mail order.
regards
ahmad
hi i have same model 2 years old its a head ach to set it up and each time you use thicknesser you have to setup from scratch fence is not good at all. there is a full thred on fence.
viewtopic.php?t=6931&highlight=record
viewtopic.php?t=6381&highlight=record
in my opinion simpley dont buy it...
hi guys need some advice please......... i am buying new band saw i have thise modles in mind Jet JWBS-18Q or Startrite 502E or hammer n4400 band saw not sure confused #-o please help.
any input much appreciated
ahmad
hi i am about to buy axminster bandsaw awhbs450n.I'd like to know if any of you guys owns one of this bandsaw and what do you think of the quality of it?