Recent content by 668hrn

I did the 1st year of my apprenticeship with the CEGB at Bankside power station. The classroom/workshops were located in sheds in front of the main building. The exhaust gas “scrubbing” involved spraying with a chalk laden mist. The contaminated chalk slurry was collected in tanks then...

Hi How about solar arrays and wind farms on the grouse moors instead of using good agricultural land?

Silly me

May be able to help. Collection and delivery points. Size and weight needed David

Good afternoon all, I am about to check over this K5, service and repair / restore. Everything seem to work. I am missing a manual. A copy in PDF format will help me along. Hopefully, a member will be prepared to assist. All the best David

Not surprised they still send me a paper bill for £9 every month.

In the early 70’s I worked with a predecessor firm of EY. One of the then big five accounting practices. Each Christmas we received a £5 Christmas box and a card. In about ‘75 we were told that as rampant inflation had eroded the value of the £5 it had been decided to no longer give a Christmas...

Luton Green Sawmill, Payhembury, Honiton, Devon EX14 3HZ

Hi I also have a Minor and am seeking a speed reduction counter shaft. Would you be prepared to sell yours? I am considering making one. Please let me know the diameter of the pulley Many thanks David

Just listen to yourselves Te He

Just listen to yourselves Ha

What are the chances for finding a Molder Block (M137), Cutters (1 - 12) and the Hold Down Spring? The Coronet paperwork describes the block as 3 1/4" Dia x 3/4" wide for any saw table with 1/2", 5/8" or 3/4" spindle. Thank you Ps I also posted this on the wanted board