Irma Peterson
New member
Hi,
I have just been given a Ryobi dovetail jig DT330, but no instructions, bush or cutter for it. I have bought a Trend GB12 bush that fits my Elu Mof96, but cannot identify what cutter would be suitable.
The spacing of the fingers (pitch) of the template is 25mm as far as I can tell (not ½").
I believe this jig was also marketed by Towa.
Does anyone have this jig and can point me at a suitable cutter (¼" shank)?
And does anyone have the instructions they can let me have a scan of?
Thanks in advance.
I have just been given a Ryobi dovetail jig DT330, but no instructions, bush or cutter for it. I have bought a Trend GB12 bush that fits my Elu Mof96, but cannot identify what cutter would be suitable.
The spacing of the fingers (pitch) of the template is 25mm as far as I can tell (not ½").
I believe this jig was also marketed by Towa.
Does anyone have this jig and can point me at a suitable cutter (¼" shank)?
And does anyone have the instructions they can let me have a scan of?
Thanks in advance.
