Search results

I have an old lamp post which I think is cast iron and would like to mount a CCTV on it and would like to know if I can drill into the pipe to run the cables.

@johnnyb Assuming you use 6x1 timber, how many metres does it take to make a chair

@Cordy how much timber do you use towards a single Adirondack and what size do you normally opt for? I have just made up the templates for mine and ready to go to stage 2.

I don't think you should block their numbers. Just be honest with them and say no thanks every time they reach out. They will have more respect for you when the reality hits them and will indeed figure out you didn't need the job in the first place.

Hi, I bought myself the Sealey Metal bender so that I can create certain structure/s or support for the garden. Here is the link to the item: https://ffx.co.uk/products/sealey-sealey-pbf04-metal-bender-floor-mounting-32631 I have tried to create a 'U' structure using 12mm rebar that are 1.5m...

Update: I did a 'bush' fix with the cable where it was severed as a test and it worked a treat. The replacement should arrive today. Thanks to you all.

I have retrieved the cable which has 6 cores and I very much doubt it’s an RJ11 I was hoping to repair it but I might have to buy a new one

I was just looking at the replacement cable and just to be clear Is the plug an RJ45 or RJ11? It’s hard to tell from the photos and there is nothing in the description. They seem quite expensive as I have put together quite a few cables with RJ45s or possibly once or twice done ones with RJ11s

I’ll revisit at the weekend and report back Thanks to all

It didn’t occur to me to check the label but I will do as soon as I can get back there. The thought of rodents chewing through it did cross my mind. But like I said earlier my knowledge is limited and I’ll have to investigate and determine where that cable was connected to assuming it was

I know virtually nothing about power showers. The MIL complained that her power shower was out of action and I went to investigate. There appears to be power going to the shower and a cable on the left attached to the shower unit in the loft. I pulled this cable gently only to find it came loose...

not long finished on a project of 11 houses and all had the insulating quilt laid over as well as 100mm Knauff insulation in between the rafters.

made with 12mm plywood and the pot is on the floor. I am unable to load the second photograph. The planter is 3x longer but I lined the inside with thick plastic sheeting and then I inserted 30mm long plastic pipes to allow the water to drain and sealed around this with silicone.

I'll have to try a different tool. The one I got is a Draper which I thought would be up to the job. Anything to avoid having to take the worktop and the sink out to replace the tap as the entire thing is all being replaced something in the Spring.

I did change both valves Next stop is to change the O ring on the outlet spout

If this is the washer you’re referring to then I can confirm I have already changed this

If this is the washer you’re referring to then I can confirm I have already changed this

To my utmost disappointment I woke up this morning to a dripping tap!!!! I just can’t figure out why

Just been out and got a seating tool. I'll report later

Just to confirm it’s the tap that’s dripping I forgot to upload the photo I took of the parts I changed Are you guys saying the tap can be replaced with that tool?