Recent content by wizard

i have had loads of ml8 lathes most 1/2 hp

just press the report button simples

My inverters are plug and go but when I fitted a remote switch I had to be talked through setting it up. It was not easy but the place I bought it from was very helpful. Also as already said you can NOT use any switch that is already on the machine.

Ok got it, just been reading the rules. As I see it if someone makes a post that may be against forum rules or a stupid post do not reply to it or have a laugh by making pointless comments about it, simples.

just had a look at them, not easy to find! maybe the mods should read them as well :wink:

they only pick on me because I am black :wink:

not me again :wink:

it looks like you are saying flanajb is a" living brain donor"

I am always getting posts removed or getting banned I don’t throw my toys out of the pram its only a forum

When I buy a machine with a three phase motor I never plug it in to my inverter anymore after plugging in a faulty one that took out one phase of my £400.00 inverter. Now I test them using single phase and a capacitor if the motor can be wired up to 240 volts the only problem is getting it to...

A die grinder and yes I have one is no good for very small things

i bought this Dremel type thing from the market i think it was about £80.00 with all its bits

no you can not if that worked every one would be doing it. and yes i do it to test 3 phase motors that way but they will not start under load

its a Scheppach it will do until i find a better one plus i will get my money back

i always do a claim as things may go wrong