I went to buy a Vacuum Clamp from Germany yesterday and could not check out as the United Kingdom wasn't listed as a country. The supplier said they no longer support purchases from the UK due to Brexit but happily supply to all other corners of the world. He redirected me to his eBay site which...
I have a new Clifton No 3, bought by me directly from flinn-garlik.
I have struggled to get a decent edge on the Cryogenic Blade and on closer inspection there is a ridge running along the back of the blade.
I have emailed them this evening.
Is there anything I should know about prepping...
Hi.
Any suggestions for replacement track saw blades for the Festool TS 160 x 2.2 x 20mm
I need a 48TPI and a rip blade, I thought Scott+Sargeant did them but apparently not
Will be at Harrogate next weekend, intend to have a closer look at the portable Festool Table saw and a 125 mm Festool Sander.
I am thinking of getting a battery sander if the batteries between the sander and saw are interchangeable.
Are there any Festool show offers that you know about...
It's not uncommon, if your edge isn't square to start with the plane will just follows what is sees. This is my approach to getting a perfectly square edge.
I am in the middle of a bathroom refurbishment. The CH supply pipework is tectite copper pushfit, probably 25 years old or more.
I feel I need to replace them as once the tiled floor is done there is no access
Options are
replace with plastic pushfit
pre soldered joints
standard soldered...
It's, solid wall with the old tiles, rather than hack it off which would probably bring off the sand and cement we may plaster board over it and skim it.