Recent content by pauljhaigh58

I have the 250 been good cutting oak etc must use good blades I use tuff saw Paul

Welcome

C35 lot better have power floated many times vidrating screed to level/ power float to polish Paul

Think it’s a no for your situation Paul

GEN3 Applications Typically GEN3 concrete is used for: Foundations Walls and house extensions Paving Shed & Garage Foundations/flooring (without steel reinforcement) Mass concrete fill Trench fill Under paving for patios Please note - GEN3 should not be used externally unless it is completely...

Hi and welcome

Welcome

Welcome back

You will need the tools to drive them in Paul

https://www.facebook.com/marketplace/item/235507009540548/

There’s a firm in Brighouse West Yorkshire that’s selling Rockwool insulation from de commissioned cold rooms I used it for my garage you buy it by pallet loads need a big van to collect

My thoughts are 1 cast shed slab first 2 leave 600 mm gap between shed-to walls (access to clear away debris)/maintainance 3 set plastic drainage grate as in font of garages 25mm lower than slab and concrete up to 4 the banking will need an upstanding to prevent storm water flooding shed 5 as...

Welcome Paul

Straight on to block

It’s hard work when you’re garage is full to start with lol but worth it good soundproofing too