Yes, SCM MiniMax T40 (bad typing :oops:), also has the cross-slide attachment. All are single-phase. I will try them on eBay and see if I get any interest. Thanks for your advice @RobinBHM.
Thanks, @Keith 66 - the space is the issue. We have got them into my garage, and even 'stacked' in (i.e. unusable!), they have taken up half of a double garage!
I am currently trying to deal with this very problem. My father-in-law died in June, and I now have a Sedgwick table saw and a Sedgwick planer/thicknesser to dispose of together with an SMC Spindle Moulder. The equipment is big and heavy (very heavy). I have approached a handful of dealers...
Thanks Bob,
Did exactly as you suggested. Loaded up the puller (not excessively, worried about the cast iron) and gave the puller bolt a sharp tap with a hammer and off they popped! Success! The only extra thing I did do was to run the pulley lock ring up to the top of the thread to make...
I have an Axminster Power Tools CH-18 Drill Press and I need to remove the spindle pulley. I have removed the locking ring but I cannot free the pulley casting from its shaft. The manual seems to indicate that the pulley is mounted on a tapered shaft, but I have tried a 3-legged puller, but it...