Molynoox's latest activity
Help Support UKworkshop.co.uk:
-
Oak and Wild Service desk I made for my daughter, still needs a couple more coats of finish and I can't make my mind up if the drawer... -
Molynoox reacted to MikeK's post in the thread Why are some router tables made up of cast iron but not others? with
Like.
I read through most of your posting history, and you appear to have come a long way in your workshop expertise in nine months (I did... -
Molynoox reacted to CaptainBarnacles's post in the thread Why are some router tables made up of cast iron but not others? with Like.
What a ridiculous argument! I get it if you are working as a chippy etc but most of the folks on here are hobbyists and do this stuff in...
-
I wanted a dog in the bench vise as well so I can hold different widths of flat stock more securely than in the tail vise I wasn't sure...
-
today made a good start on the bench dogs. the 19mm forstner came so I ripped some thin sections sapelle on the bandsaw, these will form...
-
Good question! been thinking about it. a lot! I would estimate 40hours solid work so far based since August, most of that was planing it...
-
OK! managed to sort that mistake out. I chopped off the end cap just enough to allow it to lever onto the dovetail. then I cut a...
-
managed to steal a bit more time on this. have dismantled the old thing I'd been using which served me well whilst I decided if I...
-
I've finished the leg frames and they have a coat of osmo polyx on them. I messed up one of the mortices (the lower taller ones) I think...
-
made a good start on the leg frames. I made the new legs square and coplaner ready to accept the mortices. the legs are approx 6x5"...
-
not much progress thanks to the mewling one but I've infilled the initial vice cutaway in favour of housing it in the apron. I did a...
-
so the top did this in sections so initially scrub planed the stock then refined this before using the jointer plane then glue up...
-
Been quiescent for a few weeks thanks to work being busy but finally have some bits for the new workbench built up. In addition the...
-
Hi, This is some pictures of my first ever workbench. It was my first time using planes, cutting half laps and using chisels for some...
-
Molynoox replied to the thread feasability.Well the obvious thing to do would be to cover it with membrane and then battens and then clad it with tongue and groove or composite or...