I have a great saw for my wood but it would be nice to cut some bricks with the same level of accuracy - is it possible to fit a diamond blade to the saw or is this a stupid idea?
Thanks
Miles
I am about to design and build a fruit cage for my father. It will be c. 3x8m ad 2m tall.
Initially I am thinking:
1) timber to be 2x2"
2) I will mount it on replaceable sticks into the ground to allow for rotting
3) The bottom of the legs to be connected for greater stability and ease of...
No Bob you're right it is a dewalt however the nut comes off the end of the thread which is attached to the motor (the bit with the hole in which the spindle lock engages with). This leaves the collet to come out etc.
I will endeavour to remove the bits at the end of each job (though having...
Well that was uncomfortable! I followed most / all of the suggestions above:
1) Spray of WD40
2) Tap with hammer / wood in all the ways suggested
3) Fasten mole grips and attempt to use the nut
All failed. :( :shock:
Eventually use the mole grips on their very strongest setting to hold the...
I have not used the router for a few months and now find that the bit I used is stuck in there. Obviously I can't use oil to release it as the next one will just spin so what can I do?
I have undone the nut which secured the pairing and can now see the colette but can't work out how to release...
What about (all from Brian Johnston's wiki page):
Jonathan Agnew suggested that Ian Botham was out hit wicket because he had failed to "get his leg over" - Johnston carried on commentating (and giggling) for 30 seconds before dissolving into helpless laughter
when Neil Harvey was representing...