Recent content by llywmog

factory specials page down

I got one from them. It's a lovely plane. No probs.

B&Q offer first 15 cuts for free if you have a TradePoint card (first 5 free without)

I have that one from Bangood and can confirm it's very accurate and easy to use.

oh yes

Rigid apart from connections to the gates

I use 63mm hose for all machines, including table saw, using twin motor camvac with no issues

and even if it were true, they should check this: https://www.theguardian.com/business/2023/nov/20/do-electric-cars-pose-a-greater-fire-risk-than-petrol-or-diesel-vehicles “All the data shows that EVs are just much, much less likely to set on fire than their petrol equivalent,” said Colin...

None close by unfortunately, but I managed to get the answer from another post so all is good.

Thanks Graham. Much appreciated

Hi I've searched and searched and even contacted Makita (no reply as yet) but I can't find what the lowered/locked position height is for the Makita LS1019 (I know it's 660mm when in use). Can anyone who owns one let me know what this figure is? Cheers

Hi I've searched and searched and even contacted Makita (no reply as yet) but I can't find what the lowered/locked position height is for the Makita LS1019 (I know it's 660mm when in use). Can anyone who owns one let me know what this figure is? Cheers

Hi I've searched and searched and even contacted Makita (no reply as yet) but I can't find what the lowered/locked position height is for the Makita LS1019 (I know it's 660mm when in use). Can anyone who owns one let me know what this figure is? Cheers

Here's a post to my extraction setup with AUK motor and Incra lift. https://www.ukworkshop.co.uk/threads/successful-router-dust-collection-with-camvac.144192/

That piqued my interest. Why was that? Were your family associated with the ousted dictatorship?