Recent content by Carlow52

I am based in Swords in Dublin, Ireland and have a grey version of the Multico M floor standing machine, c/w 3 chisels, 1/2, 3/8, 1/4 inch as well as a 1/8 to 5/8th chuck attachment. Its on a wheeled base. Anybody know what it might be valued at please? Thanks

Depending on the voltage drop along the cable, it may blow a plug fuse or two on startup due the the peak inrush power surge. Being a direct drive rather than belt it may not be an issue, I just flagged it so that if it happens you know why. I changed my 13 Amp on a 3hp belt driven saw to a...

The SIP one, at 3hp, may struggle on a 13 amp fuse at start up, especially if the cable run to workshop is not up to it.

Morticing, like routing is something that is better done in smaller chunks. Just think about the manual effort required to chop out a 16mm wide mortice. If the sliding table and plunge lever are set up comfortably, you will be surprised how quickly you will get it done

Many thanks for this, its back and am back in business. I also see now how it can be removed, I have only had it since 1998 so time to learn.

What is the correct way to refit it please. Shank is tapered but smooth Its a SIP drill press, floor standing. Thank you

+1 for Peltor. The brand is used by the aircraft folk in front of the jet engines:) You could explore the sound cancelling ones also: more expensive. However, quality ear and eye protection are invaluable. hearing damage is one way and creeps up on you

Looking here on thier website looks like its possible: While it saysairvalve set I think it includes the rubber bit. http://www.trend-uk.com/product/ACE_4/3 ... _off_.html Ordered them online: painless. Am based in Ireland so when I call ed the UK she said I must deal with Irish supplier...

I have two of these: http://www.amazon.co.uk/TREND-AIRACE-Ai ... uctDetails The grey bit that covers the face have perished in both so before i shell out another 50 euros each, I wonder can one source any replacement parts. Thanks

Thanks for all the input. Had a closer look today and got it to work. Its a nice item. Some questions re the tool if I may: Where is the torque regulator referred to in the scant literature I have? I tried a few trial pieces and in one case using plastic the head pulled through What is the best...

Thanks for the replies, the message went into spam so did'nt see till now. Let me try post a pic of all the kit in the box tomorrow

I bought this one in Nuneaton last week http://www.axminster.co.uk/axminster-r1 ... iveter-kit There were no instructions with it and what I got from them this morning is useless Just wonder if anyone has anything useful. Thanks ps just to add I bought this compressor also...

whats the plan for insulating the roof and then ventilation of the enclosed airspace? Rather than one long slope, perhaps make it a very flat A

On hols: there is a TV in apt with HDMI connections and I have the cable to connect DVI outlet from mac to TV. However, when playing DVD's on mac sound is only on mac speakers so quality and volume range is poor. I have my elderly parents in law with me: I can subtitle the words but not the...

Do u have the software or do you need both the pc and the xp? the reason I ask is that MS are getting more and more invasive about seeking out unlicensed XP via their use of a genuine xp validation check before some updates. Are the 3 service packs still available online if u just get the XP on...