I don't understand your first two paragraphs, that's how little I know about this stuff.
I looked at the rockler jig it and the site says $69.99 + estimated duty etc of £29 ish.
I can't justify the thick end of a ton too mess about, wish I could though.
Thanks.
I'll post a picture tomorrow. I'm not bothered about the hinge being on show, I've just watched a Matt Estlea video on hinges and would be delighted to get them looking anything like that 😄
I am just practicing to see what I can do really, gluing the sides, back front together then gluing the top and bottom on. Really basic. I like the idea of an inset lid and pin hinges... How are the pins fixed in place?
I'm messing about with 44x12mm pine and making a few boxes.
I've got to the point where I'm figuring out how to fit the hinges and want to have a go at both butt and flush hinges.
I think I've got the right size butt hinges but I've no idea what size flush hinges I'd need to properly fit 12mm...
Someone gave me a jig for making finger joints. It's made from pine and looks like the pic attached.
The gap between the fingers is 12mm. Is there a router bit (flush trim??) that will fit into that gap and fit into a trim router?
I've looked and they all seem to be 12.7 mm or larger.
Thanks.
My original plan was to mount it on top of the bench. Then I watched some David Barron videos and thought ... that looks good. I think I'll give it a go as a built in and see how I get on with it.
Thanks.
I'm looking to install a moxon vice into my bench and have started looking around at hardware.
Don't want to/can't spend too much so been looking around and found the wdscomponents one for around £65.
I'm wondering if I could buy the components for less - don't even know where to look for...