Hi Bluekingfisher,
I have gone down the same road with a Meddings jigsaw. The motor is 3 phase as you have been told/guessed. You have two options, either replace motor with similar single phase motor and you will need to purchase , ideally a no-volt release switch for this. Or you can get a...
The Katanaboy is a sharpenable blade and you can get a suitable file from Silky. They are superb saws, personally I've yet to find a bow saw that could compete with one.
I can't speak for Clarke equipment but needle guns are pretty simple animals. One thing you should be aware of is that they are air hungry, you will need a big compressor with a big tank to do any sensible amount of work.
Thanks Peter, that was my thoughts. I've never used MDF as a veneer substrate and this MDF is in multiple laminae so lots of surface area to soak up glue and then swell.
Will see what I can do for photos.
Hi,
I've been given a Backgammon board to repair. It's not of the best quality but has sentimental value. Apparently, a wooden shelf fell onto it corner on and this has punched a rectangular slot thru' one side. The MDF substrate has delaminated into several layers but I feel that with...
Yup, what Derek says. I've just done this. Didn't use a Dremel but 4.5" angle grinder with 1mm cut off disc. Mark off with a sharpie pen, follow the pen line and cut 2-3mm at a time and allow cooling time between bites. I kept one finger resting on the blade near to the cut so I could feel its...
Have a thing in my head at the moment about running up some window sashes with hand tools. Have a rather tired Stanley 45 with a nice sharp NOS cutter of the appropriate shape but I'm struggling to figure out the best way to place the fence and the sliding skate. Anyone have any experience of...