Dear all
Building a lean to shed. I need 7 150mm x 150mm PAR cedar posts circa 3m. I live in Maidstone, Kent. Any recommendations for suppliers?
Regards
Jon
Further advice please:
What spacing and pattern for fixings through the ledger board. It will be circa 5.5m long. How many fixings through it and pattern:
Alternate one through top third of ledger board face then the next through bottom third and so on?
Regards
Jon
Hi
Further advice please:
The ledger board is around 5.5m long. How many fixings are recommended and what spacing/pattern. I presume alternating through top third then bottom third of the face as you go along the ledger?
Regards
Jon
Building inspector visited. I need a building notice of works
Planning to use 80mm PIR which is ok to 4 degree slope. Flashing I need to look into/investigate. Suggestions?
Is 80mm PIR the rught thicknrmess for a lean to shed?
Any recommendations for the width of the ledger board. I will use 145mm x 47mm rafters at aroumd 5 degree angle so not sure whether to use 175mm or 200mm x 47mm?
Regards
Jon
Dear all
I have planning permission for my lean to shed.
I am going to have a ledger attached to my side wall of my house of either 175mm x 47mm C24 or 200mm x 47mm C24. It will be about 5m long. Off it will come angled rafter brackets for 145mm x 47mm rafters.
What fixings would you folk...